The below picture illustrates how a typical DVI to HDMI cable would connect from the PC to the Projector.
Please Note: You must use the Quadro graphics card port, rather than any onboard graphics card port.
Configuring a 3D DLP Projector
Started by David Richens, Jul 13 2011 02:34 PM
DLP HDMI VGA Projector
-
This topic is locked
2 replies to this topic
#1
David Richens
-
- Administrators
-
- 31 posts
Administrator
- LocationNorth Wales
Posted 13 July 2011 - 02:34 PM
Configuring a DLP Projector using a HDMI cable
The below picture illustrates how a typical DVI to HDMI cable would connect from the PC to the Projector.
Please Note: You must use the Quadro graphics card port, rather than any onboard graphics card port.
The below picture illustrates how a typical DVI to HDMI cable would connect from the PC to the Projector.
Please Note: You must use the Quadro graphics card port, rather than any onboard graphics card port.
#2
David Richens
-
- Administrators
-
- 31 posts
Administrator
- LocationNorth Wales
Posted 13 July 2011 - 02:46 PM
Configuring a DLP Projector using a VGA cable
The picture below illustrates how a typical VGA cable would connect from the PC to the Projector.
The Quadro graphics card does not come with a VGA port, and will require a DVI to VGA adaptor. (Usually supplied separately)
The picture below illustrates how a typical VGA cable would connect from the PC to the Projector.
The Quadro graphics card does not come with a VGA port, and will require a DVI to VGA adaptor. (Usually supplied separately)
#3
David Richens
-
- Administrators
-
- 31 posts
Administrator
- LocationNorth Wales
Posted 13 July 2011 - 03:17 PM
Configuring the DLP Projector for 3D
Please refer to your projector manual on how to configure it for 3D.
Generally you must enable 3D DLP in your projector 3D menu as illustrated below.
Please Note: 3D DLP mode will not appear on most projector menu's until the projector is receiving a 120Hz input from the PC.
(Refer back to Step 3 of Configuring 3D Vision.)
Configuring the PC for DLP 3D
Please refer to your projector manual on how to configure it for 3D.
Generally you must enable 3D DLP in your projector 3D menu as illustrated below.
Please Note: 3D DLP mode will not appear on most projector menu's until the projector is receiving a 120Hz input from the PC.
(Refer back to Step 3 of Configuring 3D Vision.)
Configuring the PC for DLP 3D
- Open the NVIDIA Control Panel (Refer to Acessing the NVIDIA Control Panel), click on Manage 3D.
- Enable the OpenGL stereo display method in the Manage 3D Settings tab, then choose Generic active stereo from the Stereo - Display mode:
- Turn on stereo under the Stereo-Enable entry:
